A third AGT400 has been installed at Chicago Heights’ Esmark. The AGT400 thickness measuring system will replace an outdated GR200 for use on a 60” Stamco slitter to measure the thickness of various steel alloys with a thickness of <.135”. This service center will install two more gauges this year.
Five Minute Catch Up With John Fearing
John Fearing recently completed his annual week long motor cycle trip. This year he chose to ride solo and didn’t make any pre-planned stops. He rode where the wind blew him. He ran down to southern Ohio for a day of riding in his old stomping grounds of Lawrence County and dinner with his parents. Then he dropped down into central Kentucky heading west picking up parts of the Bourbon Trail. After riding through Kentucky he rode up into southern Indiana road east along the Ohio River back into southern Ohio before swinging back north to Columbus and home. Overall he covered just under 1,500 miles in five days. A nice easy no stress trip, well not entirely no stress, ask him about Bambi and wild turkey (not the drink) the next time you see him.
AGT400 Goes To Metals U.S.A.
An AGT400 has been shipped to Metals USA in Madison, Illinois. The AGT400 will upgrade their obsolete 1996 model GR200, and be used to measure the thickness on various steel alloys on their 72” Alcos slitter. This is the third Metals USA facility to switch over to Advanced Gauging for their thickness gauging requirements.
Two AGT400 Isotope Thickness Gauges Installed
Advanced Gauging Technologies has successfully completed the commissioning of two more AGT400s at USS-Posco Industries (Pittsburg, California). Both gauges were installed on a pickle line tandem cold mill (PLTCM) and are measuring steel with a thickness range of .030 to .200”. These gauges replaced obsolete Weston 3000 thickness measurement systems.
Happy & Healthy Employees
Our employees are getting stronger and healthier each week! Pictured below (left to right) Tiffany, MeLisa and Scott are doing plate pulls. A.G.T. has seen tremendous results by implementing a group fitness program midday twice a week this includes more productive performances, weight loss, happier employees and strong team bonding.
- « Previous Page
- 1
- …
- 40
- 41
- 42
- 43
- 44
- …
- 60
- Next Page »